Sensor seguidor de linea TCRT5000
XBee S2C
Modulo XBee S2C con antena incorporada, modulo ideal para hacer prototipos y pruebas, aquí sus principales características comparándolo con el XBee3
Características
- Out-of-the-box RF communications, no configuration needed
- Point-to-multipoint network topology
- 2.4GHz for worldwide deployment
- Common XBee footprint for a variety of RF modules
- Industry leading sleep current of sub 1uA
- Firmware upgrades via UART, SPI or over the air
- Migratable to DigiMesh and ZigBee PRO protocols
- Transceiver chipset: Silicon Labs EM357 SoC
- Data Rate RF: 250Kbps, serial up to 1Mbps
- Indoor/urban range: 200-ft. (60m) 300-ft. (90m)
- Outdoor/RF line-of-sight range: 4000-ft. (1200m) 2 miles (3200m)
- Transmit power: 3.1mW (+5dBm)/6.3mW (+8dBm) boost mode 63mW (+18dBm)
- Receiver sensitivity: (1% PER) -100dBm/-102dBm boost mode -101dBm
- Serial Data Interface: UART, SPI
- Configuration Method: API or AT commands, local or over-the-air (OTA)
- Frequency Band: ISM 2.4GHz
- Form factor: through-hole, surface mount
- Hardware: S2C
- ADC inputs: (4) 10-bit ADC inputs
- Digital I/O: 15
Pickit 3 compatible + Zocalo ZIF
FPGA DE10-Lite (Comercial)
Arduino Mega R3 Original
Arduino Mega en su versión original, entre sus principales características tenemos:
| Microcontroller | ATmega2560 |
| Operating Voltage | 5V |
| Input Voltage (recommended) | 7-12V |
| Input Voltage (limit) | 6-20V |
| Digital I/O Pins | 54 (of which 15 provide PWM output) |
| Analog Input Pins | 16 |
| DC Current per I/O Pin | 20 mA |
| DC Current for 3.3V Pin | 50 mA |
| Flash Memory | 256 KB of which 8 KB used by bootloader |
| SRAM | 8 KB |
| EEPROM | 4 KB |
| Clock Speed | 16 MHz |
| LED_BUILTIN | 13 |
| Length | 101.52 mm |
| Width | 53.3 mm |
| Weight | 37 g |
Arduino UNO R3 Original
Versión Original Italiana del Arduino UNO.
Entre las principales características tenemos:
| Microcontroller | ATmega328P |
| Operating Voltage | 5V |
| Input Voltage (recommended) | 7-12V |
| Input Voltage (limit) | 6-20V |
| Digital I/O Pins | 14 (of which 6 provide PWM output) |
| PWM Digital I/O Pins | 6 |
| Analog Input Pins | 6 |
| DC Current per I/O Pin | 20 mA |
| DC Current for 3.3V Pin | 50 mA |
| Flash Memory | 32 KB (ATmega328P) of which 0.5 KB used by bootloader |
| SRAM | 2 KB (ATmega328P) |
| EEPROM | 1 KB (ATmega328P) |
| Clock Speed | 16 MHz |
| LED_BUILTIN | 13 |
| Length | 68.6 mm |
| Width | 53.4 mm |
| Weight | 25 g |
