Mostrando 1–9 de 247 resultados

Show sidebar
Close

250FT/250G PLA 3D INK® $16 EA Cobalt

S/89.00
PLA 3D Ink® is polylactic acid, a non-toxic biodegradable thermoplastic and one of the most commonly used 3D printing materials.
Close

250FT/250G PLA 3D INK® $16 EA Crystal clear

S/89.00
PLA 3D Ink® is polylactic acid, a non-toxic biodegradable thermoplastic and one of the most commonly used 3D printing materials.

5MP Night Vision Camera for Raspberry Pi

S/189.00
INTRODUCTION This 5MP Night Vision Camera for Raspberry Pi is compatible with every version of Raspberry Pi, and comes with
Close

Adafruit 9-DOF Absolute Orientation IMU Fusion Breakout – BNO055

S/175.00
DESCRIPTION If you’ve ever ordered and wire up a 9-DOF sensor, chances are you’ve also realized the challenge of turning
Close

Adaptador MicroHDMI a HDMI

S/5.00
Adaptador de microHDMI a HDMI, el Raspberry Pi 4 tiene entrada MicroHDMI, por lo que si tienes una pantalla con hable HDMI-HDMI, con este adaptador solucionas el problema y los puedes conectar sin problemas.
Close

Analog Infrared CO2 Sensor For Arduino (0~5000 ppm)

S/270.00
INTRODUCTION The concentration of carbon dioxide (0.03% usuallly) is related to daily life. Recently, there’s a study showing that the
Close

Antena 2.4Ghz para XBee S2C o XBee3 RPSMA 3dBi

S/12.00
Antena de 3dBi para los XBee RPSMA de 2.4Ghz, de los productos que tenemos esta antena es compatible con:
  • XBee S2C RPSMA
  • XBee Pro S2C RPSMA
  • XBee S3 RPSMA
  • XBee S3 Pro RPSMA
Descripcion: 2.4GHz Duck Antenna 3dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs&Xbee module. 50 ohm impedance. 4" long.
Close

Antena 900Mhz para XBee S3B RPSMA 3dBi

S/25.00
Description: 900MHz Duck Antenna 3dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 200mm long. The FCC is moving towards Part 15 compliance. All this means is that all the SMA RF connectors are changing gender. Really annoying for those of us who need to mate an antenna to an RF device. The FCC gender change was instituted to prevent home users from damaging RF equipment (think home WiFi) when screwing on an antenna. If all antennas are female, there is no way to damage the center connector. However, you have to be very sure now what kind of SMA connector you need. Documents:
Close

Arduino DUE Original

S/190.00
Arduino DUE version italiana, aqui sus caracteristicas: Microcontroller AT91SAM3X8E Operating Voltage 3.3V Input Voltage (recommended) 7-12V Input Voltage (limits) 6-16V